STRIPPER-200

APPLICATION:
STRIPPER-200 Stripping agent for engraved screen for all mesh counts after Polymerization of Photo emulsions for Rotary printing screens. It has been especially designed to remove the cured photo lacquer from the nickel rotary screen, even if polymerization of the photo lacquer has taken place at 180° deg. C, during 2 hours.

Direction For Use:
Pour the Stripper into a Polyethylene stripping tank. The Screen is immersed in the Stripper. After 15-25 minutes the engraving lacquer will become loose. This time will depend on the temperature, at which polymerization was realized and the number of times screen in used. We advise that the correct stripping time is established empirically.

After the screen has been taken from the Stripper, any lacquer remaining is sprayed off with water and then the screen is very thoroughly rinsed with water and dried.

The effect of the Stripper will slowly decrease. In general it can be stated that, the consumption is 1 / 2 to 1 liter of Stripper per screen. In case of very long stripping time, empty the stripping tank and clean it thoroughly.

Safety:
As Stripper contains hazardous solvents and other volatile organic substance there should be provision for proper ventilation in the working space and the stripping tank should be covered.

Stripper should never be allowed to come into contact with skin. When working with the stripper it is compulsory to wear safety goggles, protective mask and gloves, protective clothing and safety shoes. The most suitable material for gloves and clothing is polythene. Immediately after it has come into contact with Stripper the material must be washed off.

When the skin has been affected, rinse-off with lot of water, dry it thoroughly & then treat with fatty cream. After rinsing out with the aid of any eye-bath and a strongly diluted solution of sodium bicarbonate, on doctor’s prescription, the eyes shall be washed, after which a few drops of castor oil applied into the eye; immediately afterwards consult eye surgeon or other doctor. The above must be available in the working area.

Shelf Life : Stripper 200 can be stored up to 1yr. at a temperature of 30° C

Packing : 35 kgs. plastic carboys

> Stripper 200 known as textile rotary screen engraving chemicals, rotary engraving chemicals, Textile Mills Photo Emulsion, textile printing overseas mills, Textile Engraving Chemical Of Rotary Printing Textile Rotary Screen Engraving Chemicals Textile Printing Overseas Mills Stripper.